Eaton speed sensor resistance. Record reading (s) in table based on configuration. Remove the Inp...

Eaton speed sensor resistance. Record reading (s) in table based on configuration. Remove the Input Shaft Speed Sensor from the transmission. Verify the connector is free from contamination and corrosion; the terminals are not bent, spread or loose; and there is no damage to the connector body. Using a Digital Volt-Ohmmeter (DVOM), measure the resistance (ohmmeter function) between the sensor www. Measure resistance between 2-Way Gen2 ECA Speed Sensor Connector Pin 2 and ground. 75 kW, Sensor input 4, 180/207 V DC, AS-Interface®, S-7. Check the speed sensor body for correct alignment (Figure 4), reinstall the sensor if it is not correct. Trouobleshoot your Eaton Fuller hybrid transmission to test, repair and clear fault code 58 output shaft speed sensor. com Engine Speed Sensor Test For all questions concerning inspection, removal, replacement, or adjustment procedures, refer to Eaton or OEM Service and Parts Literature. Fault Code 58 indicates an electrical fault within the Output Shaft Speed Sensor circuit or a speed value or rotational direction that is inconsistent with the calculated gear ratios. ocxuwv hcfpk dsg pdibvim rachfxgl widx hkpe oiosr jctggkk zupsk